Product Introduction
WNS series oil/gas-fired skid-mounted hot water boiler adopts an integrated design, with all equipment assembled on one skid frame. It requires no on-site installation and exempts from inspection formalities, featuring excellent mobility.
The boiler body follows classic WNS design, which is a horizontal internal-combustion, wet-back three-pass boiler. It is equipped with full corrugated furnace and threaded flue tubes. After fuel combustion, flue gas flows sequentially through the furnace (radiant heat transfer), reversal chamber and threaded flue tube bundle (convective heat transfer), forming a three-pass heat transfer circuit and effectively expanding the heating surface area. Combined with large-volume furnace, tail-end economizer and condenser, the flue-gas temperature can be reduced to as low as 60 ℃ with thermal efficiency above 93%.
The control system is fully-automated. Equipped with ultra-low-NOₓ combustion technology, nitrogen-oxide emissions can be controlled below 30 mg/Nm³ to meet stringent environmental-protection requirements and realize fully-automatic operation.
The hinged smoke-box door allows easy access for inspection, lowering later-stage maintenance workload.
3D System Schematic Diagram

Main Performance Advantages
Product Parameters
| Rated Working Pressure (MPa) | Rated Outlet Water Temperature (℃) | Rated Inlet Water Temperature (℃) | Thermal Efficiency (%) | Maximum Transportation Weight (t) | Maximum Transportation Dimensions (L×W×H, m) |
| 1.00 | 95 | 70 | 93 | 7.3 | 8.00╳2.20╳2.32 |
| 1.00 | 95 | 70 | 93 | 8.4 | 9.00╳2.20╳2.36 |
| 1.00 | 95 | 70 | 93 | 12.0 | 9.50╳2.20╳2.40 |
| 1.00 | 95 | 70 | 93 | 14.0 | 10.50╳2.22╳2.48 |
The above data is for reference only. Please refer to the actual product and product manual for specific information. Unless otherwise specified, the right of interpretation for all data contained on this website belongs to our company.
If you require detailed information about other models, please contact us.






